Can someone verify this for me??

Hey, do you have a problem with something on your vehicle? Post the problem here someone may just have the answer for you.

Moderators: Rich Rock, Mazdahead

Post Reply
NJ 03Mach1
Novice
Posts: 277
Joined: Wed Oct 03, 2007 12:16 pm
PHA Permanent Number: 281
Current Racecar: Looking!
Location: Jersey Shore
Contact:

Can someone verify this for me??

Post by NJ 03Mach1 »

I pulled this from the Road Race section of one of the Stang Forums I go to and I just want to verify it. They say it is for ESP class...

Can any one help me out?

From the October Fastrack:

Insert new section 15.2.E after 15.2.D and re-label subsequent sections of 15.2 accordingly:
“E Longitudinal (fore-aft) subframe connectors (“SFCs”) are permitted with the following restrictions:

1. They must only connect previously unconnected boxed frame rails on unibody vehicles.

2. Each SFC must attach at no more than three points on the unibody (e.g. front, rear, and one point in between
such as a seat mount brace or rocker box brace).

3. SFCs must be bolted or welded, but welding must be to the OE subframe stampings, not to the floorpan in
between.

4. No cutting of OE subframes or floorpan stampings is permitted. Drilling is permitted for mounting bolts only.

5. No cross-car/lateral/triangulated connections directly between the driver’s side and passenger’s side SFCs are
permitted. Connections to OE components such as tunnel braces or closure panels via bolts are allowed and count
as the third point of attachment. No alteration to the OE components is permitted.

6. SFCs may not be used to attach other components (including but not limited to torque arm front mounts or driveshaft
loops) and may serve no other purpose.”

NOTE: This change affects Street Modified as well (see 16.1.G, which will be removed and superseded by the above).
July 2007
Currently looking for a Legends or Dwarf car.
Adam Sampson
PHA #281
FV195
Novice
Posts: 256
Joined: Sun Jan 02, 2005 12:38 pm
PHA Permanent Number: 195
Current Racecar: 1996 Vector GB2 formula vee, red @195
1992 Brazos formula vee, yellow, #70
Location: valrico, fl
Contact:

Re: Can someone verify this for me??

Post by FV195 »

what about motor mods? The Mach might fall into a differant class, I only know formula car rules. sorry, I sure someone will be of more help
THOR
NJ 03Mach1
Novice
Posts: 277
Joined: Wed Oct 03, 2007 12:16 pm
PHA Permanent Number: 281
Current Racecar: Looking!
Location: Jersey Shore
Contact:

Re: Can someone verify this for me??

Post by NJ 03Mach1 »

Motor Mods? Don't have any... Why would I fall into a different class?

I'm asking about the possibility of running frame connectors on this rule...

Here's the thread it's in...

http://www.corral.net/forums/showthread.php?t=962233
Currently looking for a Legends or Dwarf car.
Adam Sampson
PHA #281
User avatar
gdh57
Site Admin
Posts: 398
Joined: Mon Jun 13, 2005 12:29 pm

Re: Can someone verify this for me??

Post by gdh57 »

You can check yourself. The 2008 Solo II rulebook is online at:

http://scca.com/contentpage.aspx?content=61

If you're asking if that section exists in the rulebook, the answer is yes. Your excerpt from the Fastrack does not say when it was effective, but since it's in the 2008 rulebook, it's effective as of at least Jan 1, 2008.

Grace
NJ 03Mach1
Novice
Posts: 277
Joined: Wed Oct 03, 2007 12:16 pm
PHA Permanent Number: 281
Current Racecar: Looking!
Location: Jersey Shore
Contact:

Re: Can someone verify this for me??

Post by NJ 03Mach1 »

Thanks. I dl'd the rules to my phone memory card to upload to the PC later...


Now to get me some SFC'S!
Currently looking for a Legends or Dwarf car.
Adam Sampson
PHA #281
Post Reply